If the car battery is merely discharged but otherwise in good repair, using a NOCO charger will not damage it. NOCO chargers will not over charge a battery, once full charge is reached, the charger switches to pulse maintenance, which maintains the charge rather than applying full power to the battery.
A charger like the NOCO Genius Battery Charger and Maintainer # 329-GENIUS5 would be best suited for a car battery. The charger is suitable for deep-cycle batteries. view full answer...
With two batteries on your RV, to charge the battery bank using an external charger like the 2.5-Watt Solar Battery Charger # PTW2997 you will connect the positive side of the charger to the first battery's positive terminal and the negative side of the charger to the second battery's negative terminal. It doesn't matter if the batteries are connected to each other in series of parallel for this to be the correct connection.
With this charger you will either have two 12V batteries in... view full answer...
To charge your AGM battery on your 2015 Ford transit I recommend the OptiMate 7 Smart Battery Charger # MA37JR. This charger is capable of charging 12 volt and 24 AGM batteries as well as wet cell, gel, enhanced flooded, calcium and lithium-ion. 12 volt batteries rated up to 400 amp hours and 24 volt batteries up to 200 amp hours.
For your DC to DC charger I recommend the Redarc In-Vehicle BCDC Battery Charger - Dual Input - DC to DC - 12V/24V - 25 Amp Item # 331-BCDC1225D. This charger... view full answer...
After doing some research on the red top Optima Batteries for your 2002 C5 Corvette, the CTEK 0.8 Universal Battery Charger for Small 12 Volt Batteries # CTEK56865 will maintain a charge on your vehicle battery. This charger should also be able to maintain the charge on your deep cycle trailer battery as long as it has a capacity less than 100 amp hours. This charger can maintain batteries with capacities up to 100 amp hours, but will only charge batteries with capacities from 1.2 to 32... view full answer...
Yes you can use the NOCO Genius Battery Charger and Maintainer # 329-GENIUS10, on your vehicle with two batteries. Just attach the cable with eyelets as you would to charge or jump your batteries. Connect the positive lead to the positive post on one battery and connect the negative lead to the second battery negative battery cable connection at the vehicle frame or engine block. This charger maintainer has smart technology that will not allow it to overcharge or undercharge like common... view full answer...
That's a great question. You can use a 1 amp charger to charge a 6 volt battery, however the charger # CTEK56158 is for 12 Volt batteries. While it is still possible to charge two 6 volt batteries with a 12 volt charger, I recommend the OptiMate 1 Smart Battery Charger - AC to DC - 6V/12V - 0.6 Amp # MA82WR for your 6 volt batteries. It's much more convenient, and safe, there's no worrying if you have the batteries hooked up properly, or if they are wired in series or parallel.
The 6... view full answer...
Yes, you can have the NOCO GENPRO On-Board Battery Charger # NOC84FR connected and charging a battery while the battery is being used. The charger will continuously monitor the state of the battery and charge when needed. If fully charged it will maintain the battery.
As this charger has 4 separate banks for charging different batteries you should be sure not to connect to any batteries that are wired together in series or parallel. As when the batteries are connected the charger it could... view full answer...
For a car battery you want to use a charger designed for that application, such as one of the CTEK units shown on the linked page. For example, their MULTI US 7002 12-Volt Universal Battery Charger # CTEK56353 is a multi-step, fully automatic charger with pulse maintenance. This can both charge a depleted battery and maintain a charged one. Charging time for 80% charge of a 14-Ah battery is only about 2 hours. I have owned one of the CTEK chargers for several years and it does a good job... view full answer...
You will need to use a battery charger such as the CTEK MULTI US 7002 12-Volt Universal Battery Charger w/ Pulse Maintenance and Backup Power # CTEK56353.
The reason for this is chargers have the ability not just to charge the battery but also protect it from things like overcharging, which can cause too much heat and potentially a fire. The charger, for example, has a pulse-maintenance system so when your battery is fully charged it will simply maintain the charge instead of continuing... view full answer...
The NOCO Genius Smart Battery Charger - AC to DC - 6V/12V - 10 Amp # 329-GENIUS10 is made to charge a large variety of batteries, including lead-acid deep cycle batteries. There is not a specific mode on this charger just for deep cycle batteries, but it puts out 10 amps max which is typically the amount that a deep cycle battery should be charged at so it will work well. This is a smart charger that will make sure each battery gets charged properly without overcharging and it is the charger... view full answer...
The NOCO Genius Smart Battery Charger # 329-GENIUS2D is not going to work well with a 64 Ah battery. While technically it will be safe to hook up and use, it will take a very long time for the charger to fully charge your battery. Even for long term maintenance charging, this would not work well. We do recommend upgrading to a different charger like the # 329-GENIUS5, which will work with 12v batteries up to 120 Ah. view full answer...
Tekonsha battery charger # 2024-07 is designed for small 12 volt break away system batteries that typically have a 5 amp hour rating. If your battery is 12 volt and greater than 4 amp hours then you could use this charger provided the personal watercraft has an alternator/generator that keeps the regular battery charged.
If the battery is rated too high, like a regular car battery, the charger would hardly be effective if at all. For any charger be sure the connections you make are water... view full answer...
The Redarc In-Vehicle BCDC Battery Charger # 331-BCDC1225D is specifically designed to be used with an automotive alternator or smart alternator.
The battery charger does not necessarily force the alternator to draw more power but rather optimizes the charge generated during driving in order to provide you with more battery power and capacity when you need it. Therefore, no will not stress the vehicle's alternator.
As long as you are using the battery charger to charge a 12V lead acid... view full answer...
The Bright Way Solar Battery Charger # BRW54FR has a one way diode to prevent it from draining your battery. The electricity will flow one way and one way only. As far as over charging goes, my co-worker had this charger on his enclosed trailer ALL WINTER LONG to charge his two 6V batteries and it did not overcharge them. I don't see there being any overcharging issues at all. Your batteries will be safe with this charger.
I've used the NOCO Genius Smart Battery Charger # 329-GENIUS5 while... view full answer...
As long as the battery you have in storage can still hold a charge, you can use the 2.5-Watt Solar Battery Charger # PTW2997. A larger solar panel system could charge the battery faster, but it is not required to charge and maintain your battery power. This solar charger can be used for all types of 12v batteries like ones used for cars, boats, motorcycles, PWC and lawn tractors. view full answer...
For a simple DC to DC battery charger for your new lithium battery I recommend the Redarc In-Vehicle BCDC Battery Charger # RED96FR. This charger is compatible with AGM, gel, standard lead acid, calcium, and Lithium ion (LiFePO4) batteries and recommended for batteries rated for less than 75 amp-hours.
You will need a 23-Amp MIDI Fuse Kit for Redarc In-Vehicle 12-Amp BCDC Battery Charger # RED76FR inline between the Ram battery and charger and the 30-Amp MIDI Fuse Kit for Redarc In-Vehicle... view full answer...
I recommend using the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger # PD9245C to charge the batteries with your Progressive Dynamics Pure Sine Wave Inverter # PD64FR. There is a certain way that it will need to be wired in line with your batteries and the panels. I have included instructions below that will help you see how the converter will need to be wired with your inverter. view full answer...
The charger you would want to use for car batteries is the NOCO Genius Battery Charger and Maintainer # 329-GENIUS5, that you have referenced. It is designed specifically for 12 volt deep batteries and works well with deep cycle options. view full answer...
To recharge the Duracell Rechargeable AA Batteries # DU93QR you will need one of 2 chargers.
The Duracell Ion Speed 1000 Battery Charger # DU63QR is capable of charging batteries in 4 to 8 hours and includes 4 AA batteries with it.
The Duracell Ion Speed 4000 Battery Charger # DU73QR is capable of charging batteries in 1 to 2-1/2 hours and includes 2 AA and 2 AAA batteries.
Both charges can charge AA Batteries # DU93QR and AAA Batteries # DU43QR view full answer...
Yes, even with the battery charger installed when you are flat-towing your 2012 Honda CR-V you would still want the fuses removed. The charger will help keep the battery in good shape but the with the fuses left installed the battery would still end up depleted. The battery charger would just basically slow down the process slightly but it would not totally be able to keep up. view full answer...
Go To Results